gigasept^® instru AF

gigasept^® instru AF is a concentrate and is diluted with cold water to produce the desired application concentration.
Dosage:
depending on the degree of effectiveness 1.5 % - 4 %.
Application example:
1 litre of a 3 % working solution corresponds to 970 ml of water and 30 ml of gigasept^® instru AF.
Immerse instruments to be reprocessed in the gigasept^® instru AF solution immediately after use. Ensure complete covering of the surfaces, also of hollow instruments, and allow them to soak in the solution. Rinse all instruments thoroughly after cleaning, using water of at least drinking water quality, or preferably sterile distilled water or fully deionised water, to completely remove residues of the cleaning solution.
Do not exceed indicated contact times and concentrations. Please follow the reprocessing recommendations of the instrument manufacturers. National regulations may require that cleaning and disinfection are carried out in two separate process steps. Not for final disinfection ofsemicritical and critical medical devices!
Standing time:
A standing time of 7 days applies if the working solution is only used for the disinfection of previously cleaned instruments. If the working solution is used for cleaning, national regulations may limit the timespan during which the solution may be used.
Ultrasonic cleaning:
gigasept^® instru AF is particularly suitable for use in ultrasonic devices. The chemical stability of the product is maintained in this process. Studies have shown that very good cleaning can be achieved with gigasept^® instru AF after only a few seconds. Reference reports can be provided on request. Moreover, the stock solution should not be heated above 40 °C.

Composition:
100 g solution contains the following active substances: 15.6 g Cocospropylene diamineguanidine diacetate, 35 g Phenoxypropanols, 2.5 g Benzalkoniumchloride.